The Model 350 SHORT STOP is designed for the rental equipment dealer or tool crib that must verify the safety and performance of electrical equipment on a regular basis. It's fast and easy! Just plug in the tool, attach the ground clip and operate push buttons 1-5. No special skill or training required. This tester is ideal for repeated testing as it avoids the over-voltage potential that shortens the insulation life of the tool.
- Full 20A current capacity
- All 120V tools in common use can be tested
- Built-in extension cord tester checks polarity, continuity and ground wire resistance
- Tests quality of ground wire
- The quality and continuity of the ground circuit is measured. Poor quality ground connections are rejected.
- Verifies tool performance
- Multi-scale ammeter reads the current drawn by tool. This helps identify defective bearings, gear trains, shorted coils, or poor brush contact.
- Direct reading leakage meter
- Displays actual leakage current with good, marginal and danger levels clearly shown.
- No dangerous high voltage
- All tests are performed at normal line voltage. Repeated high voltage testing degrades a tool's insulation and presents an employee hazard.
View Your Cart
